Having Trouble With Your Traxxas Stampede

How to Remove and Rebuild a Slipper Clutch on a Traxxas Stampede 4x4 VXL

Having Trouble with Your Traxxas Stampede?

If your Traxxas Stampede 4x4 VXL is making grinding noises and isn't running properly, it could be time to rebuild the slipper clutch. The slipper clutch is a mechanism that helps protect the drivetrain from damage by allowing the wheels to slip when too much torque is applied. Over time, the slipper clutch can wear out and need to be replaced.

Tools and Parts Needed

• Phillips screwdriver
• 17mm wrench
• Slipper clutch rebuild kit

Steps

1. Remove the body from the Stampede.
2. Locate the slipper clutch at the rear of the transmission.
3. Use the 17mm wrench to loosen the locknut on the slipper clutch.
4. Remove the locknut and washer.
5. Pull the slipper clutch unit off of the transmission.
6. Disassemble the slipper clutch unit by removing the three spring pins.
7. Remove the old friction pads and springs.
8. Install the new friction pads and springs.
9. Reassemble the slipper clutch unit and insert it back into the transmission.
10. Tighten the locknut on the slipper clutch.
11. Reinstall the body on the Stampede.

Tips

• It is important to use a rebuild kit that is specifically designed for your Traxxas Stampede 4x4 VXL.
• Make sure that the friction pads are installed in the correct orientation.
• Tighten the locknut on the slipper clutch securely, but do not overtighten it.

Conclusion

Rebuilding the slipper clutch on a Traxxas Stampede 4x4 VXL is a relatively simple task that can be completed in about an hour. By following these steps, you can help keep your Stampede running smoothly for years to come.